This controller can control at a distance up to 30 strips single color 220v, thanks to its RF technology to be used paired to the remote control (sold separately),

For monocolored stripes means that they do not change colour or RGB, as for example strips-light neutral natural 4200k, warm 300k, the cold 6400k, blue, red, green, all of which have only one color.

The controller has a maximum load of 300w, operating on 220v dc , therefore you will need to combine a transformer suitable.

For each command: power on, power off, or change in intensity you need to wait a maximum time of 5 seconds from when the button is pressed.

MODE OF RECOVERY (from the remote):

Click on TO OFF for 3 seconds, otherwise click ON for a few seconds until the strip not to blink for 10 times.

More information on the remote control: https://www.silamp.it/telecomando-per-controller-rgb-dimmer-led-silamp-30mt-controllo-remoto-p-23898.html

INSTALL THE LINKS:

Check that the unit is not present exterior damages .

Pay attention to the links, as they can not be connected directly to the contrary.

The entrance (input) of the controller must be connected to the cables of 220V network: the PHASE with L (line) and NEUTRAL with No

The output of the controller connects to the strip LED 220V:

• W: wire is the NEGATIVE – (minus sign, usually black) of the strip LED 220V
• + : wire to the POSITIVE + (plus sign, usually red in colour) strip LED 220V

See details in the following image.

SPECIFICATIONS

Contenido del paquete:

Ø 1 Controlador de LED 220V